Myalarm V-LCD1 Instrukcja Obsługi Pobierz pdf (Strona 282)

LCD MESSAGES

B-276

System 2 Installation / Programming Manual

Mem Clear = All memory was cleared.

Module Reset = One of the small processors have reset.

Net Noise = Electrical noise has been detected somewhere on the network.

On Line = Program mode was exited.

PIN Error = After a valid card was used, the code which followed (Card & Keypad)

was incorrect.

Program Mode = Someone entered program mode.

Relay Override = The relay was manually switched.

Request-To-Exit = The RTE button or Passive Infrared was used to exit a door.

Sched Error = Schedule Error. A user tried to enter a door during an invalid

Time Schedule.

Slave Down = One of the Slaves has lost communications with the Master Unit.

System Reset = Reset button is pressed on circuit board.

Timeout = The System has timed-out of program mode and returned on-line. The

System automatically times out if programming has ceased for five

minutes.

Unknown Event = If this event appears consistently, call Corby Tech department.

Unv = This will precede any card number or Data Chip which has been

programmed using the universal mode.

Valid User = A valid code / card was used to enter a door.

Zone On = A zone has been triggered On.

Zone Off = A zone has been triggered Off.

1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 335 336

Brak uwag

Myalarm V-LCD1 Instrukcja Obsługi Strona 282