Myalarm V-LCD1 Instrukcja Obsługi Pobierz pdf (Strona 265)

WINDOWS PROGRAMMING & MODEM SETUP

10-259

System 2 Installation / Programming Manual

CHAPTER 10

WINDOWS PROGRAMMING &

MODEM SETUP

Introduction

Getting Started

Determine which COM port you will be using for your connection to System 2. If you are unsure,

use Microsoft's Utility program MSD to assist you in determining which ports are available.

Making the Connection

All COM ports on PCS are either 9 pin or 25 pin male connectors. To make the connection from

the System 2 to the PC, you will need a 5 conductor 22 gauge cable with an overall shield.

If you’re using a 25 pin connection at the PC, follow the illustration in Figure 13.

Your connection should be:

9 Pin Connector (P1) - System 2 25 Pin Male Connector (PC Location)

Pin #2 - RXD Pin #2 - TXD

Pin #3 - TXD Pin #3 - RXD

Pin #5 - GND Pin #7 - GND

Pin #7 - RTS Pin #5 - CTS

Pin #8- CTS Pin #4 - RTS

If your using a 9 pin connection at the PC, your connection should be:

9 Pin Connector (P1) - System 2 9 Pin Connector (PC Location)

Pin #2 - RXD Pin #3 - TXD

Pin #3 - TXD Pin #2 - RXD

Pin #5 - GND Pin #5 - GND

Pin #7 - RTS Pin #8 - CTS

Pin #8- CTS Pin #7 - RTS

Select the baud rate on System 2

U Select Option 18 (Baud Rates).

U Enter the number that corresponds with the fastest baud rate possible.

U For hardwired connections 9600 is best, press 3, then # .

1 2 ... 260 261 262 263 264 265 266 267 268 269 270 ... 335 336

Brak uwag

Myalarm V-LCD1 Instrukcja Obsługi Strona 265